Battery Hold Down Strap
When I first got our trailer and we decided to go with 6v batteries I went a head and purchased a Torque Lift 6v battery box....to expensive @ $300.00 but it is a nice product. The hold down set up t...
Forum Discussion
I felt compelled to check my batteries with a hydrometer so I unleashed these bad boys and figured I'd give you a better view of the corner pieces. This is an end shot showing the piece that goes down the side of the batter to stabilize the corner pieces when the strap is tightened.
This is the cut out to go over the battery lift assist. I cut all this with 10" table saw that has a very good carbide plywood blade on it. I tell you, that Plexi-Glass is way harder then any hardwood I've ever cut..................
And this is the other side of cut out showing how I fastened the stabilizing plate to the cut out piece. All pre-drilled holes with Stainless Steel Screws.................. As you can see, moderation is not a strong point with me! It was so nice this morning when I just popped all this stuff loose to check the batteries and it all went back together so easily!
This is the cut out to go over the battery lift assist. I cut all this with 10" table saw that has a very good carbide plywood blade on it. I tell you, that Plexi-Glass is way harder then any hardwood I've ever cut..................
And this is the other side of cut out showing how I fastened the stabilizing plate to the cut out piece. All pre-drilled holes with Stainless Steel Screws.................. As you can see, moderation is not a strong point with me! It was so nice this morning when I just popped all this stuff loose to check the batteries and it all went back together so easily!
