CheapHeat furnace conversion
I was wondering if anyone has converted their factory installed LP furnace to the CheapHeat system. Seems like a very practical system when connected to shore power. No worrying about running out of g...
Forum Discussion
Tim: Great question. I know that several have made the mistake of ordering the wrong installation kit, not realizing there are three.
I think I can clear that up for you. There is only one heating element and it is used in every plenum. The power output is controlled by the components of the installation kit, with the largest being model DH-50.
Part of your confusion was caused by me. I mis-spoke when I said DH-37, you want DH-50. That will give you the most BTU.
I sincerely apologize for causing the confusion. I had three members PMing me at the same time, requesting information on the system. :o
I think I can clear that up for you. There is only one heating element and it is used in every plenum. The power output is controlled by the components of the installation kit, with the largest being model DH-50.
Part of your confusion was caused by me. I mis-spoke when I said DH-37, you want DH-50. That will give you the most BTU.
I sincerely apologize for causing the confusion. I had three members PMing me at the same time, requesting information on the system. :o
