Ecoworthy 20a settings?
I just installed an ecoworthy 20a controller and a 235watt panel. I have two Trojan 145plus 6v batteries. A few questions on settings: -For the Bulk, Absorb and float voltage settings I was plann...
Forum Discussion
coruss wrote:
-For the Bulk, Absorb and float voltage settings I was planning on using 14.8, and 13.2 per the battery spec sheet. What should I do for the float voltage?
-"Over discharge protection voltage".....Not sure what to do here?
-"Discharge restart voltage".....Again, not sure?
I think this gizmo has only 2 settings: Absorb and Float. If battery specs call for 13.2 Float, then set Float to 13.2.
Absorb voltage is what they call Constant Current voltage or Overcharge voltage. A mystery of Chinese engineering mentality.
Over discharge is when it disconnects the load, set it to 11.8 maybe. Restart is when it reconnects the load - it should be set higher.This is - if you use those "load" terminals. But you don't have to.
Be aware that this thing doesn't know what the battery temperature is, and all temp comp adjustments are per controller temperature.
