Forum Discussion
csorba
Jul 02, 2013Explorer
Here are some completed picture of this completed project ( almost complete, just needed 1 more elbow)
Hope other people can use this information.

-New Water Tank installed under bed, from D&M Plastics from Lacombe AB, RFW 1040 model and it holds 168 liters or 44 gallons

-Vent lines and missing elbow

-high level shot showing angles and plumbing

-Close up of gate valve and 3/4 tank and tee fitting. the tee is 1-1/4" barbed by 1-1/4" barbed by 3/4" threaded. The gate valve is 3/4" threaded and I used some irrigation fittings.

-New water fill mounted above factory

-New water fill from American RV, this one is lockable and includes a 1/2" vent line as well as 1-1/4" fill line

-New lines showing back of fill fittings

-Shows new lines from inside the passthrough to the under bed storage.
Hope other people can use this information.

-New Water Tank installed under bed, from D&M Plastics from Lacombe AB, RFW 1040 model and it holds 168 liters or 44 gallons

-Vent lines and missing elbow

-high level shot showing angles and plumbing

-Close up of gate valve and 3/4 tank and tee fitting. the tee is 1-1/4" barbed by 1-1/4" barbed by 3/4" threaded. The gate valve is 3/4" threaded and I used some irrigation fittings.

-New water fill mounted above factory

-New water fill from American RV, this one is lockable and includes a 1/2" vent line as well as 1-1/4" fill line

-New lines showing back of fill fittings

-Shows new lines from inside the passthrough to the under bed storage.
About DIY Maintenance
RV projects you can tackle on your own with a few friendly pointers.4,397 PostsLatest Activity: Dec 04, 2025