Propane Piping ?
I this type of elbow ok to use in this application
Forum Discussion
Per NAPA 58:
Pipe shall be wrought iron or steel (black or galvanized), brass, copper, or polyethylene (see 3-2.10.8) and shall comply with the following: (a) Wrought-iron pipe — ASME B36.10M, Welded and Seamless Wrought Steel Pipe (b) Steel pipe — ASTM A53, Specification for Pipe, Steel, Black and Hot-Dipped, Zinc-Coated Welded and Seamless (c) Steel pipe — ASTM A106, Specification for Seamless Carbon Steel Pipe for High-Temperature Service (d) Brass pipe — ASTM B43, Specification for Seamless Red Brass Pipe, Standard Sizes (e) Copper pipe — ASTM B42, Specification for Seamless Copper Pipe, Standard Sizes (f) Polyethylene pipe — ASTM D2513, Specification for Thermoplastic Gas Pressure Pipe, Tubing and Fittings. Pipe shall be recommended by the manufacturer for use with LPGas. Polyethylene pipe shall be marked in full compliance with the product marking requirements of ASTM D2513, and shall include the manufacturer’s name or trademark, the standard dimensional ratio of the pipe, the size of the pipe, the designation polyethylene (PE), the date manufactured, and the designation ASTM D2513
Pipe shall be wrought iron or steel (black or galvanized), brass, copper, or polyethylene (see 3-2.10.8) and shall comply with the following: (a) Wrought-iron pipe — ASME B36.10M, Welded and Seamless Wrought Steel Pipe (b) Steel pipe — ASTM A53, Specification for Pipe, Steel, Black and Hot-Dipped, Zinc-Coated Welded and Seamless (c) Steel pipe — ASTM A106, Specification for Seamless Carbon Steel Pipe for High-Temperature Service (d) Brass pipe — ASTM B43, Specification for Seamless Red Brass Pipe, Standard Sizes (e) Copper pipe — ASTM B42, Specification for Seamless Copper Pipe, Standard Sizes (f) Polyethylene pipe — ASTM D2513, Specification for Thermoplastic Gas Pressure Pipe, Tubing and Fittings. Pipe shall be recommended by the manufacturer for use with LPGas. Polyethylene pipe shall be marked in full compliance with the product marking requirements of ASTM D2513, and shall include the manufacturer’s name or trademark, the standard dimensional ratio of the pipe, the size of the pipe, the designation polyethylene (PE), the date manufactured, and the designation ASTM D2513
