Repositioning Copper Piping
Hi all,
I have a 96 Rialta and I'm trying to reconfigure some existing, stock copper piping that supplies propane.
I'm not trying to do anything drastic, I just want to reshape at a little so it's out of the way, and move the endpoint so it's a few inches to the side.
So I'm wondering... what are the rules surrounding safely bending copper piping? Do you just bend it as you like, while keeping an eye on it to make sure you don't rupture the pipe?
It looks as if the copper pipe was already manually shaped into place, for the previous appliance it hooked up to.
Thanks!
I have a 96 Rialta and I'm trying to reconfigure some existing, stock copper piping that supplies propane.
I'm not trying to do anything drastic, I just want to reshape at a little so it's out of the way, and move the endpoint so it's a few inches to the side.
So I'm wondering... what are the rules surrounding safely bending copper piping? Do you just bend it as you like, while keeping an eye on it to make sure you don't rupture the pipe?
It looks as if the copper pipe was already manually shaped into place, for the previous appliance it hooked up to.
Thanks!
