30 Amp Service ?

30A Service........LINK

That's it. Most important part is to shut off the main breaker before you start!!!! Fron there, it is very simple to add a new circuit to an electrical box. You just have to remove the cover, snap out a tab, run your wires, snap in a new circuit breaker and re-install the cover. Minimum 10 guage wire is necessary.

assuming your panel has spare space.. its that easy

Thanks guys will do !

However you take the wiring through the outside wall make sure it is sealed vermin and waterproof and use an outdoor covered box. We did that when we lived in Maine and it was a great help since we parked our 5'er next to our house and left it plugged in. The trailer's cable was just long enough. Oh, and depending on where you do it be careful with the lawnmower and trimmer!

Bob

Make sure and remind the electrician that a 30 amp rv outlet is 110 volt.

Check the electrician uses a single breaker.
And let him show you on the meter 120v.

The link from OldBiscuit has all the needed info and ever the correct outlet designations. Give a copy to your electrician. Check when he installs the equipment. Simple and easy.

Maybe it would be wise to put in a 50A service and use an adapter. If you move up to a 50A rig you won't have to re-do!

I just plug my fifth wheel in the outlet in the garsge in it runs the AC and lights just fine.