5er roof options

minnow wrote:
From what others have reported on getting their RV's reskinned with EPDM/TPO, and the costs of such, I'd look at RV Armor roofing. It's certainly not any costlier and it comes with a lifetime warranty.

What is roughly the cost for RV Armor, say a 40 foot fiver? Is it recommended for a new roof? Ours is one year old RV but I don't want issues once we begin to travel and I don't like heights, scared to death up there.

If the tears are small, RV armor will probably still work. Call the company and ask. They may want a picture.

From what others have reported on getting their RV's reskinned with EPDM/TPO, and the costs of such, I'd look at RV Armor roofing. It's certainly not any costlier and it comes with a lifetime warranty.

If it's not the seams, such as edges around A/C or vents, then I would go with the rubber. It is more cost effective although it is not cheap. Hopefully all you have to do is reseal seams. Hopefully you don't have a lot of inside damage.

clinte89 wrote:
I was to understand that an rv roof with holes in the rubber would not be good with the rv armor. If it would work well that would be great. I only have one or two small tears the rest of t is in good shape.

With RV-Armor, or a similar product, the roof is =stripped=, right down to the wood. Any repairs to the decking are done, then the coating is applied and all vents, antennae and A/C units are replaced. I looked in to this for my FW, but it was about 60% of the value of my trailer, so I declined. No =way= I'd ever recover that on sale.

Lyle

The two most popular roof materials...EPDM and TPO...were invented for use on flat roof commercial buildings and years ago adopted by the RV industry. Both are good but TPO has advantages over EPDM. TPO can be scrubbed where as EPDM should never be scrubbed....it removes material designed to protect the remaining membrane. Also TPO repairs can be done better because TPO can be fused the way plastic drain pipe is glued together giving a permenant seal. I for one have used Eternabond and will never use it again. Inspect and touch up the sealant once or twice a year and I have never had a problem...unlike with the EB tape.

Coach-man wrote:
All RV's have rubber roofs, options,rubber roof!

Rubber EPDM membrane has proven over the years to be a very cost effective solution and as such is the most commonly used by many trailer manufacturers but some (KZ Spree being an example) instead feature a TPO vinyl membrane. Many older roofs used to be metal and on smaller trailers such as the RPod the fiberglass front wall curves up to form the roof and then back down to form the rear wall, all as one continuous piece. Alpha Systems which produces the majority of RV roof membranes has also introduced new roof membrane products such as AlphaPly and Superflex ... so to suggest that "all RVs have rubber roofs" is simply not true at all. There are plenty options available other than EPDM rubber that the OP may choose for his roof repair.

I have been hearing about truck bed liner sprayed on the roof. does add a quite a bit of weight though

I was to understand that an rv roof with holes in the rubber would not be good with the rv armor. If it would work well that would be great. I only have one or two small tears the rest of t is in good shape.

More often than not, it's the seams and edges where a RV roof fails. Check out eternabond.com. If you really want to seal things up, IMHO, this is the way to go. Run a line of eternabond tape around all your skylights, antennas and edges and you've gone a really long way towards eliminating water entry points.

*edit*
Of course my note above was intended to help with a repair. The link above to RV-armor is one of the best solutions I've seen to refinish the entire roof.