Converter Fried
Ok, so my Cedar Creek converter died last fall during the last trip out and I am getting ready to replace the lower unit in the converter. Upon taking it apart to inspect, the circuit board was fried...
Forum Discussion
Well, it sounds like most are leaning towards the Progressive Dynamics. Is the install of the PD very simple? I am certainly not an electrician and when taking the old unit out, took good notes and it was a simple uninstall but was planning on putting back in the same unit to simplify the reinstall.
It has been a while since I looked at my notes, but as I recall, all I had was a black and white coming down from panel. I had to disconnect a white from the back of the bank and a black from a ground. Any corrections and assistance on what it takes to reinstall the PD?
It has been a while since I looked at my notes, but as I recall, all I had was a black and white coming down from panel. I had to disconnect a white from the back of the bank and a black from a ground. Any corrections and assistance on what it takes to reinstall the PD?
