Do landing gear legs need to be timed?
Had a problem with my landing gear. Sheared the shear pin. We were able to make a pin to get me by till I got home. My question is do the legs need to be in line or timed? I ask because when I was...
Forum Discussion
No need to wrench them around. I just had this happen to mine broke the shear pin.
While hooked up to the truck lower the legs 2 -3 inches disconnect the drive shaft then measure the lowered jack on the drive side and the non-drive side, raise or lower the drive side to match the non-drive side and reattach drive shaft.
While hooked up to the truck lower the legs 2 -3 inches disconnect the drive shaft then measure the lowered jack on the drive side and the non-drive side, raise or lower the drive side to match the non-drive side and reattach drive shaft.
