Equal bearing for both sides of landing gear?
My first 5th wheel had separate controls for the landing gear so this was never an issue but my new one is just one switch. How concerned do I need to be about getting both sides of the landing gear ...
Forum Discussion
Ok, so I have been wanting to do this for a while and have not gotten to it yet but since no one has mentioned it I wonder if I'm missing something. If you drilled additional hole in the outer leg that were say 1.5" higher than the current holes, wouldn't that give you the option of half inch incraments? Thusley you could concivably be within a 1/4"?
Am I thinking right? Like a verneer caliper?
Am I thinking right? Like a verneer caliper?
