fixing slide out
Have a bedroom slide that I need to change electric motor on. System is Swintec. Bedroom slide is all the way in and I need to get it partially out to remove motor. Unplugged motors from controller...
Forum Discussion
smarty wrote:Then page 8 directs you to take off the facia on the outside of the slideout. Don't know how big yours is, but you would probably want to talk to someone that has done it before to get a general idea of what to do to take it off and put it back on again.troubledwaters wrote:
Did you read the instruction about pushing the mode button 6 times than pressing and holding it the seventh time until controller goes into override mode? Page 7 Here!
Yes, tired this a few times with no luck
But, I always was under the impression if you disconnect the motors, you can push the slideout out (Albeit, with a lot of muscle). However, calling LCI (Tech Services number is in that manual also) would be a good idea at this point.
