furnace
do you have to hi-point after replacing blower wheel in furnace model hydro flame 8500 series hi-pot or hi-point ???
Forum Discussion
What do YOU mean by hi-point?
If you are asking about checking run-out/out of round then NO.
If you purchased the correct replacement blower wheel for your model just slide in on shaft and tighten securely. Check motor clamp is tight.
Rotate wheel and check that is spins free.
Not a critical tight clearance machined component. :B
If you are asking about checking run-out/out of round then NO.
If you purchased the correct replacement blower wheel for your model just slide in on shaft and tighten securely. Check motor clamp is tight.
Rotate wheel and check that is spins free.
Not a critical tight clearance machined component. :B
