Forum Discussion

Rough2000's avatar
Rough2000
Explorer
Aug 16, 2014

Jayco Designer refrigerator problem

I have a 2009 Jayco Designer with a Norcold N1095 refrigerator. I recently had knee surgery and had left the trailer plugged into 120 volts. Today I went to check on the trailer and the refrigerator was warm. It was flashing codes LI and oP. Does anyone know what these codes mean? I cannot find them in my operators or installation manual. Any suggestions?

3 Replies

  • Old-Biscuit's avatar
    Old-Biscuit
    Explorer III
    Aug 16, 2014
    'LI' 'oP' fault-----------The High Temp Limit Switch is OPEN.
    Cuts power to fridge when activated. IIRC 300*F ?
    Check for ammonia smell, yellow powdery residue from a crack tube.

    If so.....cooling unit is BAD.

    IF just a fault switch/////
    Switch is on burner stack......thermal disc. Plugs into control board.
    Part # 2M0802..........LINK
  • newman_fulltime's avatar
    newman_fulltime
    Explorer II
    Aug 16, 2014
    there is a black box on the back of the fridge you will see a red led light get a strong manic run across it this resetsvit.if that does not reset you can unplug and bypass but replace as soon as posible
  • racer4's avatar
    racer4
    Explorer
    Aug 16, 2014
    I did a search. A few ;) people have talked about this.

    Click here to find these discussions.

    They are talking about the "High Temperature Limit" switch. The previous discussions should help more than I can.

    Good luck!

About Fifth Wheel Group

19,033 PostsLatest Activity: Mar 03, 2021