Landing gear motor.
08 landing gear on Cedar Creek has one mot. It really labor’s. Can a guy remove the head banger shaft that crosses from drivers side to curb side and attach a second motor. This would make for unobs...
Forum Discussion
Measuring where that bottom grease zerk is, its 4" from the top of the cap. I would not think it would matter if that hole was drilled in the front of the leg , where it would be easy to drill. All there is in there bedsides the long worm gear is a eight sided nut ,held in there for the worm gear to run thru . That hole would not hurt a thing, you could tape over it if concerned with any debris getting in there , it would be minimal inside the compartment there . Worth a try for the sake of hole.
