joebedford wrote:
I was thinking of adding a 2nd motor to my Atwood (I think) jacks. What went wrong with yours?
the second motor helped but I kept stripping the bevel gears at the top of the jacks, it would start to "skip" and then I'd have to rebuild them, real PITA. I was at the point where I was pretty sure there was something amiss inside the leg(s) and was going to replace them but decided that was a bit extreme and stop wasting time and money on a marginal setup. I have all the wiring, motor, shaft, etc. for the dual motor setup if you want it its yours just figure out how to get it from Burbank to your place.
