XP4 in Attitude

This is my 2014 XP1k 2 seater with the aluminum roof

Stock RZR 4 seater - heights
800 - 75"
900 - 77"
1000 - 73.5"

Normal rear bed clearance is 74". You should be good with the 1000.

We have the exact same model eclipse 32 aklg you are talking about.

I am 6'2" and walk under the raised beds without having to duck under so I would think your XP4 would fit under without any problem.

If more clearance is needed, the bottom bed/couch is easily removed, by pulling four k-clips/pins and lifting it off, but really at that point the XP4 wouldnt clear the door opening anyway, as both beds raise to be flush with the top of the rear door opening.

I think you are good to go, but throw the tape measure around to make sure.

Strabo wrote:
Back in the day, members would cut the cage and make it a folding one, those work perfect.

I would never trust a roll cage after its been cut. Not worth my life to clear a bed...

An aftermarket cage is also an option. THey typically sit lower and look much better but are $$.

i think i just loosened the bolts on my bottom bunk to give me another inch or two of clearance. good luck!

Back in the day, members would cut the cage and make it a folding one, those work perfect.

Just went an measured it roughly 79-80.... inches from ground to bottom of the bunk.

I just got my 32 attitude trailer with the dual beds.. it has a " high clearance" option on it.. essentially the lower bunk slides INTO the upper one when in storage.. its almost as thin as a single bed. Ill have have to measure it tonight to see what the clearance is exactly but I think you will be fine.

My XP1k is a two seater but I drive under and past the beds no problem. Same trailer. I have the bed above the couch/bed deal.

The RZR 1000s are noticeably taller than previous models and have only been out for about a year.

See the first pick on this page comparing the two: http://www.wildcatforums.net/forum/wildcat-general-discussion/5733-great-real-xp-1000-vs-900-write-up.html