50 amp rig using 30 amp pedestal
when plugged into 30 amp pedestal, the monitor panel shows 2 legs (or at least 2 separate 120 volt readings. Now I understand, I think, why 50 amp power plug would show 2, 120 volt lines because there...
Forum Discussion
For an Energy management system to "SEE" 2 legs, those legs must NOT be on the same "Phase" from the electrical supply. Since you are combining 1 phase of the supply (The Y), That is why your EMS system (any EMS system) does NOT sense and show separate power on each leg. 30 amp service is on 1 phase/leg. 50 amp service is on 2 separate out of phase legs. Doug
