After drilling all of my holes last night for the drawer sides, I decided to wait until today to fasten them together.
After posting last night, I went to bed, and I thought to myself --- "You didn't just do what I think I did, did you"?
After a little thought, I realized I did do something, not the smartest thing I have ever done.
Results below.
These are the ends that get screwed in the drawer. It dawned on me that I had indeed drilled holes in the top of the drawer ends, where no screws will be installed.
Duh! Lol.
The redeeming factor is that the one in the front end of the drawer will be covered by a finish plate. The one in the rear will only ever be seen if the drawer is completely removed.
As a result, I am not going to do anything about these extra holes.
