Atwood water heater problem
More problems.Our atwood hw heater is not heating properly.The flame is a pale blue.I can not adjust the air flow with the slide on the inlet to make the flame hotter.I am thinking it might be the sol...
Forum Discussion
If you carefully let a little water out of the relief valve into a cup and check the temperature you should see about 140 degrees unless you have one with a mixing valve. Then it should be about 160 degrees.
If the temperature is right then you probably have a cross feed from cold to hot somewhere. Either the mixing valve if you have one or a winterizing diverter valve are possibilities.
If the temperature is right then you probably have a cross feed from cold to hot somewhere. Either the mixing valve if you have one or a winterizing diverter valve are possibilities.
