Class A body roll
I know this topic has been covered many times. I purchased a 2016 Fleetwood bounder 35K this year with a 22,000lbs F53 suspension. These are very tall rigs and very top heavy. I performed the cheap...
Forum Discussion
DunellenGuy wrote:
We have a 2004 Fleetwood Southwind with a Workhorse chassis that also has a lot of roll. My family has complained of motion sickness in the back. Any special considerations for the Workhorse?
Motion from the rear axle aft is going to be extreme relative to in the cab area no matter what. You are being leveraged with every move. We had a 2004 Southwind 36' on WorkHorse and drove it 8 years and 110,000 miles. At some point we did change to Bilstiens and the improvement was noticeable, but not worth the cost if the old shocks hadn't been worn out. I cannot imagine any modification that will reduce motion behind the rear axle. Even our current DP is much rougher over the rear end than up front.
