Did I just fix my front end sway bar?
After doing work on the overcab noise makers, we were surprised to hear what sounded like a jostled stack of lumber. I thought it was from overhead, but Martha thought it was from below. I found a s...
Forum Discussion
Nice vids by Tito.
You guys shamed me into putting fancy store bought bushings, thus saving a piece of inner tube for some other future redneck fix. The new 2 center bushings went on fine w/ a little grease on the bar and the 4 bolts. I felt all around on the end linkage rods and bushings and they reallydo seem OK. But I will know now to monitor them.
Will report on sway and noise improvement (including reworked overcab fixes) when we newt take it for spinercise.
I am telling Martha we should try to pull straight out driveway into our 30' wide street. The near 12' wheelbase will allow about18 ft to turn 90 degrees into the far lane w/o reversing. Yes/No? The 12" curb transitions a 4" driveway slab elev down to 3/4",then street elev.
You guys shamed me into putting fancy store bought bushings, thus saving a piece of inner tube for some other future redneck fix. The new 2 center bushings went on fine w/ a little grease on the bar and the 4 bolts. I felt all around on the end linkage rods and bushings and they reallydo seem OK. But I will know now to monitor them.
Will report on sway and noise improvement (including reworked overcab fixes) when we newt take it for spinercise.
I am telling Martha we should try to pull straight out driveway into our 30' wide street. The near 12' wheelbase will allow about18 ft to turn 90 degrees into the far lane w/o reversing. Yes/No? The 12" curb transitions a 4" driveway slab elev down to 3/4",then street elev.
