Electric steps Part II Crunchhh!
Some may remember my post about my step not retracting a few weeks back while in Stockton, TX when I posted seeking advice? Anyway, they did retract after tapping on the motor, and all was good. So I ...
Forum Discussion
AVA, I like the bright LED idea. My 88 Bounder need engine work (carb) and the shop had me wait in the lot next door. I sat there with my door hooked open. When they called me I started the engine and BENT my steps getting over to the shop. I went down the lip at the street/curb area (where you nomally go).
Luckily mine were only bent a little and I easily repaired them.
When my steps got a little slow, getting grease and oil on all the step joints solved that problem.
Luckily mine were only bent a little and I easily repaired them.
When my steps got a little slow, getting grease and oil on all the step joints solved that problem.
