furnace

Todd757 wrote:
2008 Fleetwood Discovery. Last used our furnace in April. Worked just fine. Turned it on this past weekend, nothing happened. No fan, no heat. Checked breakers and fuses. Anyone have any ideas?

Thanks. Todd.

I assume you have a good 12V power supply and the thermosat is working?

Propane and its on?

The thermostat works with AC, and electric heat. I'm assuming it's working correctly.

Todd757 wrote:
The thermostat works with AC, and electric heat. I'm assuming it's working correctly.

your sure you have 12V at the furnace? when you turn the stat on or set temp "higher" than current room temp do u hear any clicks at the furnace? that should tell u if stat is sending signal or not

you have to flip the switch on that thingy behind the door says on off and it will work presuming its a attwood heater

newman fulltimer wrote:
you have to flip the switch on that thingy behind the door says on off and it will work presuming its a attwood heater

why or how would that be turned off?

Yes I have propane. When I turn the thermostat from heat to off, or cool to off I hear a click from the thermostat

Todd757 wrote:
Yes I have propane. When I turn the thermostat from heat to off, or cool to off I hear a click from the thermostat

BUT?? as asked do u hear one at the furnace????

You mean from the panels outside? Or something on the inside?

Todd757 wrote:
You mean from the panels outside? Or something on the inside?

where the furnace is? If the vent is outside yes stick your ear there have your ole lady turn the stat off/on a couple time and make sure temp is set higher than current air temperature
iam just trying to make sure the stat is sending a signal your heater motor may have quit but the stat will still send a signal and there should be a click
if not pull the cover and see if the circuit board is powered up when the stat is activated using a 12V tester