Generator problem - only one leg

I would have ask for at least a PARTIAL refund from him..

AND Then found a new technician.

Well, the tech where I had it serviced, forgot to connect one of the two breakers, thus the one leg failing. He also forgot to reinstall the cleanout plug for the muffler. Had to drive 45 mins each way to get the plug. My consolation? He said he was sorry. Not really, he had my $1,000. So much for trusting them.

NoSnowInAZ wrote:
Took the cover off the ATS - all looks good - tightened all lugs, points clean and operating.

So, while the cover was off, what voltages were present, if any, coming from the genset?

NoSnowInAZ wrote:
Took the cover off the ATS - all looks good - tightened all lugs, points clean and operating.

but did you measure incoming and outgoing voltage to verify if the leg drop is before the ats?

The genset has two breakers, 30A each. Yes, I did reset them, twice

Did you reset the breakers on the generator? Turn them off and back on. Don't just look to see if they are on.

NoSnowInAZ wrote:
Generator problem - I have a surge guard protector. Shore power all is ok. (50 amp)
When disconnected from shore power and crank up genset, (7000 Onan gas) my surge guard is telling me I am only getting one line (leg). No power to coach.
Both circuit breakers on genset are on.
Any thoughts?

What do you mean "one leg?". Your 7K Onan gas has one 30 amp service to the transfer switch and one 20 amp service to the second A/C.

Richard

Took the cover off the ATS - all looks good - tightened all lugs, points clean and operating.

Turn off all power if wacking the ATS doesn't work, even if it does take off the cover to the ATS and tighten all the power lugs, both the two ins and the out. While you have it open fire the gen and check power from the gen side with a meter. Should tell the story of what is going on or not.

LEN

NoSnowInAZ wrote:
Generator problem - I have a surge guard protector. Shore power all is ok. (50 amp)
When disconnected from shore power and crank up genset, (7000 Onan gas) my surge guard is telling me I am only getting one line (leg). No power to coach.
Both circuit breakers on genset are on.
Any thoughts?

your 50 amp surge guard wont show both legs on 30 amp but getting no power from gen set sound like the ATS is defunct