Has anyone installed sway bars on their own?
Hi folks, I've been looking at both Hellwig and Roadmaster and the instructions seem fairly straightforward, other than needing to drill into the frame. I'm considering having a shop do it but the...
Forum Discussion
wolfe10 wrote:
Said another way, it is not a complex job-- but drilling a frame rail requires the right tool and a bit of knowledge in how to drill through metal (proper bit, proper drill RPM, lubrication...).
I'm all ears. My hamfisted approach has been to buy a good metal bit, switch the drill to high speed, and act like I was a CNC drill with the motion (plunge slow at high speed - after drilling a pilot hole - while spraying fluid, pull drill out to clear chips and repeat).
