help furnace again
I replaced the board I jumped the sail switch got fan running it fired up and ran once now all I get is the fan to run then it quits???
Forum Discussion
sssooo wrote:
There is a switch that says reset and off should I
leave it on reset?
That is a On/Off Circuit Breaker Switch
On/Off used for 'maintenance' to shut down DC
CB trips if high amp raw
It should be ON and Reset
Fan runs...is that when the thermostat closes (temp set point higher then room temp)?
When fan runs doe it TRY to light off?
Sparking (Click, Click, Click) ?
Does flame Light off then go out??
Brand/Model....very helpful!
