Making new center console UPDATE!
The OE dash layout is terrible at best! The monitor is too low and the radio is so low it’s almost unusable! And the HVAC controls are far too low. Not to mention the cup holder being on the floor an...
Forum Discussion
Ok made some progress. Got the oak face cutout, still waiting on the radio (hopefully for Christmas) then i can make that cutout. I got all the spacers for the back side to mount everything. Still trying to find the material to wrap the console, probably go with a dark brown.
The monitor is temporarily mounted. I'm thinking of just using some 1/4" oak to mount it. It's a little floppy right now. Or I may use another piece of channel at the bottom to hold it solid. The small cubby is for the TST TPMS color monitor. I still need to cutout and install 2 power outlets, 1 on each side of the switches.
I'll update again after I get the radio mounted up.
The monitor is temporarily mounted. I'm thinking of just using some 1/4" oak to mount it. It's a little floppy right now. Or I may use another piece of channel at the bottom to hold it solid. The small cubby is for the TST TPMS color monitor. I still need to cutout and install 2 power outlets, 1 on each side of the switches.
I'll update again after I get the radio mounted up.
