Making new center console UPDATE!
The OE dash layout is terrible at best! The monitor is too low and the radio is so low it’s almost unusable! And the HVAC controls are far too low. Not to mention the cup holder being on the floor an...
Forum Discussion
Another update
Well I am just about done. Only thing left is to cut and stain some oak trim to cover the staples. Turned out pretty good. The Stan is abit dark, but it should be close to the dash wood look trim.
I'm not sure on the stainless screws! I'll leave them for now, but if I don't like them I'll get some black oxide screws so they don't stand out.
Now I need to get the MH home and install it. Then I can work on my lower console with the cupholders.
Well I am just about done. Only thing left is to cut and stain some oak trim to cover the staples. Turned out pretty good. The Stan is abit dark, but it should be close to the dash wood look trim.
I'm not sure on the stainless screws! I'll leave them for now, but if I don't like them I'll get some black oxide screws so they don't stand out.
Now I need to get the MH home and install it. Then I can work on my lower console with the cupholders.
