Ride Height P-30
I was recently in an accident and had the left side of my front end replaced. Upper A arm and ball joint lower A arm and ball joint inner and outer tie rods and a new tire. In addition the RH lower A ...
Forum Discussion
We just got back from Canada with no internet. When I had my P30 I ran across this and asked over at irv2.
I was thinking about replacing my ball joints and ran across this
Posted December 25, 2005 12:48 AM Hide Post
Neil,
Remember to use lower ball joint # K6175 from Moog,this is a common mistake by parts suppliers that look up a P30 & give you a K6122.This has a much smaller shaft,although it looks the same.The K6175 is specific to the P32 chassis.You should expect to pay 185.00+ for this part.
Mike Bronzini
Brazel's Rv Performance
www.brazelsrv.com
Check out our new WEBSITE
Your safety & comfort is our Goal!
__________________
1998 36ft Country Coach Magna #5499
Gillig chassis with a Detroit series 40
2002 F250 CC 7.3 PSD Highly Modified
I was thinking about replacing my ball joints and ran across this
Posted December 25, 2005 12:48 AM Hide Post
Neil,
Remember to use lower ball joint # K6175 from Moog,this is a common mistake by parts suppliers that look up a P30 & give you a K6122.This has a much smaller shaft,although it looks the same.The K6175 is specific to the P32 chassis.You should expect to pay 185.00+ for this part.
Mike Bronzini
Brazel's Rv Performance
www.brazelsrv.com
Check out our new WEBSITE
Your safety & comfort is our Goal!
__________________
1998 36ft Country Coach Magna #5499
Gillig chassis with a Detroit series 40
2002 F250 CC 7.3 PSD Highly Modified
