TFT Code for ScanGauge 2 ??
I have a new ScanGauge 2. Using the Xgauge feature I can't get a legit reading for the Tx temperature. The literature I have found offers codes with optional 01 at end if doesn't work. Also alternat...
Forum Discussion
rgatijnet1 wrote:
Try not using the VPW protpcal and use the CAN protocol. The Allison 6 speed uses CAN (Controller Area Network) protocol and the command goes something like this, 07E2F1221940. This breaks down to 07E2 = command to the TCM, F122 = mode and 1940 = transmission PID code. The key to this is 07E2 part... and what the TCM returns to that command.
I appreciate your suggestion, thank you! I tried the 07E2 with and without the added 01 on the end, no luck, was blank. Welcome any other ideas to try... :?
