TPMS for the alcoa wheels
Has anyone installed a system in their alcoa wheels? If so what brand? A dealer tried to install in the wheel ones for me but said they would not let the tires go pat without messing them up. I tol...
Forum Discussion
On mine, Bob.... it is a mix (typical), i.e., a steel wheel inboard and an Alcoa outboard. Both have very little clearance over the hub and are, in fact, a bit of a tussle to get off. The lug nuts are the "built-in-washer" type.....not conical and they only call out 140 ft-lb of torque .... stamped on the lug nuts. That is the config for 16" wheels, dunno about larger ones. I believe the GVWR is the same for all steel as for the Alcoa-wheeled rigs with 16" wheels.....if that's germane.
