Wierd bathroom water problem

I always used one of those inline filters connected to the hose whenever I filled the fresh water tanks or whenever I hooked up to RV park water. This is in addition to the filters that I have inside the coach for drinking water, etc. I usually have to change that inline filter every 6 months or so because of the accumulation of debris that I stop from coming in to my coach.
Even with the filters, hard water will leave more crud as it evaporates and leaves the minerals behind.

SOLUTION:

As most of you said, it appears to have been simple debris accumulation from the hard water we're hooked up to.

About 3 months ago we were getting low water pressure at the home where we're parked with full hookups. So, figuring that water in a residential neighborhood would probably be ok, I removed our water filter. Not much change in pressure, but I left it off.

And then the problem, as I described above.

I removed the easy-to-remove filters at the end of the nozzle on both sinks and it was thick with white gravel-like material. Cleaning that improved the flow somewhat in the bathroom, but not completely. As I was disassembling the bathroom faucet I broke a part and so had to buy a new one. When I installed it, flow was fine. So I have to figure something in the old faucet was blocked.

Now, what about the potty?

Mounted to the rear of the bowl is a disc with holes in it, through which flows the water which fills the bowl, and which had become so slow. I had to remove the toilet, but I found the bolt which holds that disc in place. I removed it, shook the disc, and some white particles fell out. I couldn't disassemble it, but the wife soaked it in vinegar for an hour, and said that when she rinsed it, quite a bit of white junk came out. I reinstalled the disc, and the potty, turned the water on, and the flow is fine. We're fixed.

So....moral is, don't remove that external water filter. And when something like this happens, think first of the *easy* solutions. I just didn't realize we had such "hard" water, and that buildups like that were possible. And to have two unrelated outlets slow down at virtually the same time? Well, I probably should have bought a lottery ticket. Thanks much to all who contributed ideas and suggestions.

dave

There is blockage at the faucet, disassemble and clear it out. It could be small a piece of gasket or something similar. It doesn't take much!

I’m curious if this problem was resolved, and if so, how.

Old-Biscuit wrote:

DFord wrote:
The first thing I'd check is to see if there's a check valve in the outlet of the water heater. If you have just one valve to change to winterize, you probably have a check valve. The check valve has a small disk that blocks the flow of water back into the water heater. That disk is plastic/nylon and is held in place with a spring. I've seen several of them come loose from the spring and lodge in the outlet of the water heater. It's hard to get to the back of the water heater to get at the check valve. There's no maintenance. You must replace it. I found a replacement with a metal disk right next to ones with the plastic disk. Choose carefully.

HOT water works....OP has issue with COLD to bathroom sink and toilet



OP....
Tolet sprayer works (as desgin---only when toilet is flushing)
but you have low flow to toilet.
That suggests toilet inlet to bowl/rim is plugged up with minerals/debris
Same with that cold side of faucet.

X2 Probably minerals/debris in system has broken loose and those were either the first two used.

Ken

I had a similar situation with sudden low cold water pressure in one fixture. I turned off the water spigot outside, opened my cold low point drain, disconnect the cold feed pipe tp the problem faucet, and shot compressed air into the pipe. Upon reconnecting the faucet, full water flow was restored, but it happened again a few days later, so I had to repeat the process. Some crud was restricting flow, and then it made its way to faucet screen

This is one reason the primary reason for good or great water filters for every bit of water that enters the Motorhome not just the the drinking water spigot.Every new Motorhome has a built in filter system but older ones,, some don't, and mny times no body changes them and they bypass dirty water into the Coach. I've trying to figure out how to intall a filter inside our bay with limited space

This is one reason the primary reason for good or great water filters for every bit of water that enters the Motorhome not just the the drinking water spigot.Every new Motorhome has a built in filter system but older ones,, some don't, and mny times no body changes them and they bypass dirty water into the Coach. I've trying to figure out how to intall a filter inside our bay with limited space

DFord wrote:
The first thing I'd check is to see if there's a check valve in the outlet of the water heater. If you have just one valve to change to winterize, you probably have a check valve. The check valve has a small disk that blocks the flow of water back into the water heater. That disk is plastic/nylon and is held in place with a spring. I've seen several of them come loose from the spring and lodge in the outlet of the water heater. It's hard to get to the back of the water heater to get at the check valve. There's no maintenance. You must replace it. I found a replacement with a metal disk right next to ones with the plastic disk. Choose carefully.

HOT water works....OP has issue with COLD to bathroom sink and toilet



OP....
Tolet sprayer works (as desgin---only when toilet is flushing)
but you have low flow to toilet.
That suggests toilet inlet to bowl/rim is plugged up with minerals/debris
Same with that cold side of faucet.

The first thing I'd check is to see if there's a check valve in the outlet of the water heater. If you have just one valve to change to winterize, you probably have a check valve. The check valve has a small disk that blocks the flow of water back into the water heater. That disk is plastic/nylon and is held in place with a spring. I've seen several of them come loose from the spring and lodge in the outlet of the water heater. It's hard to get to the back of the water heater to get at the check valve. There's no maintenance. You must replace it. I found a replacement with a metal disk right next to ones with the plastic disk. Choose carefully.