Direct TV revisited
Hello Question: Do you still get any programing from SD and DNS? As of Jan 31st all my programing on my D11 receiver disappeared with code 722. Well after many contacts with DTV one of the agents...
Forum Discussion
Gdetrailer wrote:missnmountains wrote:
I am not sure of the accuracy of the OPs post. I have a KVH M3 satellite dish on my boat that can only receive SD channels. I am using a h-24 receiver. I just walked out to the boat and am still receiving all of the channels I normally get.
Ken
ERROR 722
"Error Code 722: Service Expired
If you see this message, your DIRECTV receiver may not have the programming information for the channel you’re trying to view.
To get your channels back, reset your receiver:
Unplug your receiver’s power cord from the electrical outlet, wait 15 seconds, and plug it back in.
Press the Power button on the front panel of your receiver. Wait for your receiver to reboot.
If you still see the error message, call 888.388.4249 for assistance."
Dead receiver perhaps?
Receiver disconnected or unplugged for too long perhaps?
If unplugged too long the receiver can get too far behind on software updates or lose authorization..
Not able to get authorization perhaps?
Dish misaligned?
Latest software issue perhaps?
Seen a post from 2019 that mentions a software update caused that error and a reboot/refresh and rehit fixed it.. SEE HERE
Check alignment and LNB signals?
OP may also need to reboot and refresh several times after verifying they are getting good LNB signal..
Ours went dead with the 722 code, they told us we would have to update the equipment to get service back, the tech said we would not be able to use it in the motorhome after that so we cancelled. We are going get dish and a wally for motorhome
