Dish, Winegard, and signals
Recently installed the Winegard Roadtrip T4 to replace a Roadtrip SD that was obsolete with the change in DISH signals. When I installed, I had to get Winegard tech support help due to older receiver ...
Forum Discussion
"""Does the receiver show the correct SW64 switch? Does the receiver show that you are getting a good signal strength on any or all of the satellites? Have you tried to follow the Winegard Check Switch procedure again? If so, have you tried a Check Switch with no coax connected to clear the switch and then following the Winegard procedure again "exactly". """
Yes to all. I went on the Winegard page, unplugged the coax, followed exactly the installation instructions. After check switch test the page showed no satellites as it cleared previous memory. This morning I'm going to unplug the receiver power cord and the coax and again follow the Winegard check switch instructions. If I get nothing again I'll give Dish a call and see if they have an answer. Winegard of no help this weekend.
Yes to all. I went on the Winegard page, unplugged the coax, followed exactly the installation instructions. After check switch test the page showed no satellites as it cleared previous memory. This morning I'm going to unplug the receiver power cord and the coax and again follow the Winegard check switch instructions. If I get nothing again I'll give Dish a call and see if they have an answer. Winegard of no help this weekend.
