GDS-3950BH wrote:
JimK-NY wrote:
Fortunately when I looked for my RV, I found a dealer who could help. He recommended a manufacturer who does a quality job. Maybe the fashion and style were a bit lagging, but the construction and design were not.
And that manufacturer is???????
When I was looking for a camper, I was lucky enough to find Bill Penney at Truck Camper Warehouse. There were several brands he advised against including a couple of the most popular brands. He recommended Northstar. I ended up buying a used Northstar from him.
My Northstar is now approaching 20 years old and is in great condition. It has been used for full timing and has been driven for close to 100,000 miles. Sure some parts have worn out. I have had to replace 2 of the Happijac motors and 1 jack due to water intrusion. The water pump wore out and I also had to replace the sensor for hot water tank. The plastic hinge on the stove vent broke and I replaced that with a metal hinge I made from a coat hangar. I have had to replace the propane sensor twice and I am on my third set of propane pigtails.
When it comes to poor design and poor construction, I have only had two issues. The kitchen countertop was made with a pressboard core that does not hold up to water. Northstar used a router to bevel the edges of the countertop and water started to damage the countertop. I had to seal the edges with epoxy, otherwise there would have been substantial damage instead of barely noticeable swelling. The second design issue was just crazy. There is a plastic box where the wiring from the happijac motor enters the camper. The cover was installed upside down with the wire entering from the top instead of the bottom. After years of use the seal failed and left just a pinhole where water could enter the camper. I did not notice that when the camper was left outside over the winter. The water damaged the corner of a storage compartment and I had to spend an entire weekend fixing the damage.
All things considered I feel that I got a well made camper.
