Chevy 1996 zr2 s10 towing 4135 lb dry camper

Went to cat scale today. Following this from a post I found with how to use the weights.. And from another post I had in towing.

http://forums.woodalls.com/Index.cfm/fuseaction/thread/tid/27282746/srt/pa/pging/1/page/1.cfm

Weighing #1 -- TT attached and Weight Distribution Activated
Let Front Axle Load be "FA1"
Let Rear Axle Load be "RA1"
Let TT Axles Load be "TT1"

Then, while in same position on scales, take
Weighing #2 -- TT attached and Weight Distribution Not Activated (WD bars unloaded, but hanging in place)
Let Front Axle Load be "FA2"
Let Rear Axle Load be "RA2"
Let TT Axles Load be "TT2"

Then, drive off scales and drop TT. Return to scales and take
Weighing #3 -- TV only -- TT Not Attached
Let Front Axle Load be "FA3"
Let Rear Axle Load be "RA3"

From the above values, you can calculate:

TV weight = FA3 + RA3 4480

Gross Combined Weight = (FA1 + RA1 + TT1) 8820
{should also be equal to (FA2 + RA2 + TT2) if scale weights are correct}

TT Weight = Gross Combined Weight - TV Weight 4400

Tongue Weight = (FA2 + RA2) - (FA3 + RA3) 420 or [COLOR=]340 with WD

Load Transferred to TT Axles
when WD System is Activated = TT1 - TT2 80



My axle weight ratings on truck are 2700 lbs

My truck GVWR is 4900 lbs

This was empty just me in truck. Propane filled. Seems I have 500 lbs to work with on the truck side roughly.

These #'s look right?

You see no #'s are over my axle ratings. Also none of the combined axle ratings go over my GVWR


Here are my 3.

1 WD activated
2 WD unhooked
3 truck only




WD activated



WD disconnected.



Truck only

Moderator edit to re-size pictures to forum limit of 640px maximum size.