Dinghy Towing and brakes
I have a question, we are new to dinghy towing and we are currently trying to find a vehicle that has the capability to tow 4 down. We have a few vehicles in mind, but have a question concerning the ...
Forum Discussion
rk911 wrote:obgraham wrote:I will not cut into any of my toads wiring for diodes, etc.I think likewise.
But the Honda CRV's were nifty in that there was an empty sector in the rear light assembly, so I had a separate tail/brake light placed here with its own wiring.
after a disasterous first-time towing experience with diodes I did the same with my Jeep Wrangler...separate tail light bulbs and a totally independent wiring harness for them used exclusively when towing.
On the other hand, I've been towing RAV4's since 2008 that I've fully wired using diodes so all rear lights function normally including the high center brake light, with zero problems in 45,000+ towing miles. All of my wiring tie-ins were done behind the driver's side kick panel, with no need to route wires all the way to the back.
