For those of you with Propride P3 hitches...
On my Propride P3 hitch, I have the adjustable tilt pin at the bottom to prevent the stinger from tilting down. That leaves about a 1/4" gap at the top. Is there any reason I couldn't put a steel wedg...
Forum Discussion
Once torqued mine has never come loose. The rivet goes in the top, then use your floor jack to lift up on the stinger so it is forced against the rivet and tighten all the bolts.
Using this procedure mine has stayed tight.
Linc
Using this procedure mine has stayed tight.
Linc
