Furnace Cycling - SOLUTION w/ Pictures
EDIT: This turned out to be an air flow issue. The solution was quite simple. The furnace has three knockouts on the back when using flexible vent duct adapted to hard in-floor ducting. Crossroads has...
Forum Discussion
Not sure how to fix this.
I pulled the vents off the connection in to the floor and let them blow straight in to the room and the furnace runs fine. I looked and there are no blockages in any of the vents. There is very poor air output from two registers furthest from the furnace, but there are no obstructions.
I'm at a loss for how to fix this.
In looking at it, they basically are blowing hot air in to a giant duct that just spreads out to each vent and it's all connected.
Damn.
I pulled the vents off the connection in to the floor and let them blow straight in to the room and the furnace runs fine. I looked and there are no blockages in any of the vents. There is very poor air output from two registers furthest from the furnace, but there are no obstructions.
I'm at a loss for how to fix this.
In looking at it, they basically are blowing hot air in to a giant duct that just spreads out to each vent and it's all connected.
Damn.
