It is almost that simple.
Remove arms (Caution one arm will be spring loaded on the roller this one will make like a propeller if you are not careful,, there is a way to lock it)
Slide the fabric out of the roller tube and store.. NOTE: Fabric is in two tracks on the tube so remove carefully.
Note also.. Some put a screw in one of those tracks to keep it from sliding. Remove screw first.
At the top end you may also find a screw or two.. Remove
Now the fabric is splined into a channl.. Two choices
One (What I did) Spread the channel a bit either before or aft of the fabric,, Slid it toward the wide spot and out -or-
2: Remove the spline if you can then pull the fabric out
Fold or roll fabric, Seal all holes and job done.
