Hot water down cold drains?

Assuming abs or pvc drain material, not very likely, It is hard to bust that stuff when you try to do it.

We pump hot water down frozen pipes at minus -40c to unblock them and have never had issues.

I had to convert -40C to F and found out it was -40F haha... thats pretty darn cold...

Roy Ken

Not an issue at all. The hot water will not harm anything

ABS and PVC pipe fittings are not "glued" together, rather they are solvent welded together. That means the joining ABS or PVC surfaces literally dissolve and flow together, making a properly done joint one continuous piece of ABS or PVC with the same expansion contraction characteristics throughout.

Although it probably does not hurt them, I have never liked pouring very hot water down the pvc pipes. The pipes below the sink are not glued (or solvent welded), they have screwed fittings with gaskets. Even at home if I need to pour out very hot water (such as when draining pasta) I always turn on the cold water to mix with the hot water as it goes down the drain.

The Plastic Pipe Institute recommends that the temperature of continuous water flow in PVC pipe not exceed 150*F in non-pressure applications.

RoyB wrote:
I had to convert -40C to F and found out it was -40F haha..

I had to convert minus -40 and it's 104F.

ABS plumbing is used in your RV drain system......same material that is used in your home plumbing drain system

THANKS guys. That makes me feel better.

MudChucker wrote:
Assuming abs or pvc drain material, not very likely, It is hard to bust that stuff when you try to do it.

We pump hot water down frozen pipes at minus -40c to unblock them and have never had issues.

So what do you do when winter hits in Manitoba? lol (-40 is the summer temp, right?)