Liquid Wrench Dry Lube for Slideouts

My mfr recommends no lube at all. Are you talking about the big under-slide rails?

My slide(s) mfg. also recommends no lube..........as in grease

Just wire brush rail teeth


BUT...
Since beginning of 2007 I have been using a dry graphite lube spray after wire brushing the rail teeth down. Goes on wet/sticks then drys. Doesn't attract dirt/grim BUT will rub off SO Careful Where you spray it.
Also use it on rear stabilizers pivot/contact areas and front landing gear inner and driven legs.

I spray silicone on a clean rag and wipe down the hydraulic piston shaft.

When FTng I would do the above monthly......past 2 yrs just bi-yearly

Also would put talcum powder in a sock and wipe down slide out seals/wipers

Thanks; I need to check my book. Its a Jayco. Any maintenance forum or youtube video you see says to use a dry lube.

Also for the rubber seals, I saw a manufacturer demo and they used silicone spray on a rag????

It's Polytetrafluoroethylene, essentially Teflon. I have used the dupont brand of this for years on my slide rails and gears. Never caused a problem.

Lowe's has dropped the Dupont version so i bought the wd-40 version. Appears to be the same stuff. I noticed LW makes it with and without the for RV markings

So far have checked my main Jayco manual. No mention at all in regards to "how" to maintain them but that they are virtually "maintenance free". Need to see if I have another manual for the slides themselves, which I doubt.

On our new rig the guy who did our walk through said use plain silicone twice a year on slide out.

On our new rig the guy who did our walk through said use plain silicone twice a year on slide out.

I use a spray dry silicone lube that I buy at Walmart on any moving/joint friction surface. This includes slide tracks, gears, stabilisers, hitch jack, and power awning components.

Yeah it's tricky one. I haven't checked the slide manuals yet, but if I don't see anything that tells me I should lube them, don't think I'm going to. Or maybe I will. Damnit!!!!! lol

Never heard of powdering seals? What does that do for them or protect?
Slide rails on my old camper had remnants of grease on them.
I used chain wax (motorcycle chain lube). Good shear strength and less mess,like the stuff the op is looking at.