Loose Grab Handle
The grab handle by the front door has three screws on top and three screws on bottom. The ones on top are loose. I've tried tightening them but it only works for a short time. There isn't much behi...
Forum Discussion
"Drill out the holes and rout the bit around at an angle, creating a cone in the interior foam. Inject some epoxy, power grab, liquid nails etc into the holes, then reinstall the handle after it has cured."
Great idea, the epoxy is the right choice. Liquid Nails simply will take a LONG time to be hard enough to hold a screw. Vac the holes out prior to inserting the epoxy.
Once the epoxy is cured pre drill screw holes the diameter of the screw minus the treads.
Great idea, the epoxy is the right choice. Liquid Nails simply will take a LONG time to be hard enough to hold a screw. Vac the holes out prior to inserting the epoxy.
Once the epoxy is cured pre drill screw holes the diameter of the screw minus the treads.
