Second bent hitch pin
I resently purchased a 2015 F250 from a 2001 and now am having problems with bending my hitch pin. The first one I was like eh it was a cheep pin. Had to get it quickly because I wasn't aware of needi...
Forum Discussion
RooDude09 wrote:
Got the shank today. Much to my dismay it would not slide into my receiver. I got it in by pounding it in. Figured the paint needed to wear off. Once in the pin holes would not line up!! I could get the pin in one side but not out the other. Not sure if the tight fit is causing the problem or if the hole is drilled at an angle. For now went to Walmart and got the Reese reducer. The hole on it is a 5/8 hole and not Oblonged so I will see if that works till I can get a shank that fits. Hopefully I haven't banged up the shank I got so much that I'm out $140
:E:S:( That is a bad deal, stuff shouldn't be this difficult.............
