Stabilizer question on TT, what's your rule of thumb

I carry 6x6 blocks with rope handles and place them under the rear stabilizers so they do not extend as much....wider the stance the more stable/less wobble

X-chocks/wheel chocks on both sides

After setting up side/side and chocks----disconnect from truck
Run front landing gear legs until trailer is level (or tongue jack on bumper pull)
Then lower front 1" below level.......run rear stabilizers down onto the blocks until SNUG
Raise front of trailer back up to level.

Rig is now 'tight/stable'

Next AM tighten up on X-chocks