"Vintage" Reese Dual Cam WDH
Hi all! I happend upon a WDH at a garage sale for $5 and just couldn't pass it up! I didn't really know what I had until I did a little research. Turns out I have the original ("vintage") dual ca...
Forum Discussion
Thanks for the responses Barney! I read that post and there is a lot of great info there on setting up things. But, I have a couple of follow up questions.
The shank that came with the hitch is not adjustable as you can see from the picture above. Can I use this one instead?
When setting the hitch up, I should take my measurements and get it all set up while leaving these loose?
And then tap them into place? Just trying to get it all down before I attempt this.
Also, I know the bars may be light in the long run, but we don't put much in the camper and I doubt my tongue weight is near 750#. Only way to tell is to get it set up and head to a scale.
Lastly, anything to replace on these other than hardware? I was going to remove all the bolting, blast it all, paint it, and reassemble.
The shank that came with the hitch is not adjustable as you can see from the picture above. Can I use this one instead?
When setting the hitch up, I should take my measurements and get it all set up while leaving these loose?
And then tap them into place? Just trying to get it all down before I attempt this.
Also, I know the bars may be light in the long run, but we don't put much in the camper and I doubt my tongue weight is near 750#. Only way to tell is to get it set up and head to a scale.
Lastly, anything to replace on these other than hardware? I was going to remove all the bolting, blast it all, paint it, and reassemble.
