Winterizing Q
I use air to blow out the lines and I did drain the water heater. So the question is can I leave the bypass valves in normal position or do I need to put them in the bypass mode? Thanks
Forum Discussion
wildtoad wrote:
If the lines are clear, no water in the heater, and you don’t plan on using the RV the position of the valves don’t matter. I assume you have open any low point drain valves, put RV antifreeze in the sink/shower p-traps.
Though Dtoad is 100% correct I put 'em in bypass.. Just to be safe.
I also don't replace the plug and on an atwood I pull a wire off the ECO module been glad I did that once. (It's in the instructions, the wire is RED ECO is Emergency Cut Out, sets the FAULT light if you try to use the water heater that way)
