170VAC coming from my Onan generator
It's a 1995 4000 BGE. I posted earlier but wanted to focus in on this problem. I tested the lead coming into the breaker switch and it was a consistent 170 VAC. What should I check next and h...
Forum Discussion
Update:
Replaced brushes and springs.
Shined the rings.
That brought my stationary ohm reading into tolerance on the 9/10 pins at 25 ohms.
Problem is during spinning the ohms flucuate from 0.00 to OL at those same pins.
I think I have a short in the rotor.
Replaced brushes and springs.
Shined the rings.
That brought my stationary ohm reading into tolerance on the 9/10 pins at 25 ohms.
Problem is during spinning the ohms flucuate from 0.00 to OL at those same pins.
I think I have a short in the rotor.
