1986 30P Avion trailer Electrical Problem
I lost the entire 12 volt side of my electrical system and was able to determine that the 30Amp Breaker/kill switch on the monitor panel that you select to bring the battery in or out of the system wa...
Forum Discussion
Your refer could be a three way unit. LP, 12 volt DC and 120 volt. Blowing the 30 amp fuse could indicate that the unit is trying to operate on 12 volts DC and the heating element is grounded.
First what is make and model of refer?
Open exterior access, look at the stack on the right side, see if there is two small wires and two larger wires entering the stack. Follow the two larger wires back to the circuit board if equipped. Disconnect one of them. Tape it up and install new fuse. If the element is bad fuse will or should not blow.
First what is make and model of refer?
Open exterior access, look at the stack on the right side, see if there is two small wires and two larger wires entering the stack. Follow the two larger wires back to the circuit board if equipped. Disconnect one of them. Tape it up and install new fuse. If the element is bad fuse will or should not blow.
